1. THIS IS THE CAR YOU USE ON THE WEEKENDS AND FOR GOING TO THE BEACH. THE DOORS ARE FIXED TO THE CAR. YOU DON’T HINDGE THE HOOD AND TRUNK BECAUSE YOU USE RACE-CAR STUDS AND CLIP-PINS TO HOLD THE HOOD AND TRUNK LID IN PLACE.
2. THIS CAR PROJECT CAN BE COMPLETED IN 30 DAYS AND WHEN COMPLETE IT IS DESIGNED TO DRIVE WHEN IT IS NOT RAINING BECAUSE THERE IS NO WINDSHIELD WIPER AND NO-TOP. BRAKE LIGHTS, BLINKERS AND HEADLIGHTS MUST BE WORKING FOR SAFETY. YOU CAN USE RAIN-X ON THE FRONT GLASS INSTEAD OF WIPERS IN CASE YOU ARE CAUGHT IN THE RAIN.
3. USE A 1990-1999 TOYOTA MR2 WHICH IS A MID-ENGINE CAR WITH A 5 LUG BOLT PATTERN. YOU USE ONLY THE INNER DOOR PANELS FROM THE MERCY-2 N.T. LAMBO INTERIOR KIT.
4. INSTALL 4 WHEEL ADAPTERS TO THE MR2 & INSTALL 4 REAL LAMBO WHEELS AND TIRES THAT YOU CAN GET FROM EBAY.
5. YOU INSTALL A 1996 NISSAN MAXIMA WINDSHIELD AND ADD NO DOOR GLASSES TO THE SIDE VEHICLE DOORS. CUT THE BODY-KIT AT THE BOTTOM PART OF THE WINDSHIELD AND SLIDE THE BOTTOM WINDSHIELD CORNERS INTO THE BODY. USE BLACK METAL MESH FOR THE GRILLS THAT CAN BE BOUGHT AT ANY HARDWARE STORE.
6. USE FACTORY 1994 ACURA LEGEND TWO DOOR TAIL LIGHTS AND FIBERGLASS THEM INTO THE BODY OR FIND A BETTER FACTORY TAIL LIGHT FROM A SALVAGE YARD THAT LOOKS GOOD OR USE THE REPLICA TAIL LIGHT HOUSINGS WE OFFER TO BUILD YOUR OWN REAR TAIL LIGHTS BY ADDING THE PLEXIGLASS LENS AND THE L.E.D. RED LIGHT BULBS OR BUY REAL LAMBO REAR TAIL LIGHTS FROM EBAY FOR ABOUT $850.00 EACH.
7. USE THE PROJECTOR BULBS FROM A 1992-1996 ES300 LEXUS HEADLIGHT FOR THE HEADLIGHT BULBS OR USE PROJECTOR BULBS FROM EBAY OR BUY ANY TYPE HEADLIGHT BULB FROM ANY AUTO PARTS STORE TO MAKE THE HEADLIGHTS WORK. YOU CAN INSTALL AN ORANGE TURN SIGNAL LIGHT INSIDE THE HEADLIGHT LENS NEXT TO THE PROJECTOR BULBS.
8. USE THE MR2 DASH AND REDO THE INTERIOR AS YOU WISH AS TO MAKE IT MORE LIKE A REAL LAMBO. YOU COULD EASILY REDO THE MR2 SEATS IN A YELLOW AND BLACK COLOR AND ALSO COVER THE DOOR PANELS IN RED AND BLACK VINYL.
9. PUT EXHAUST PIPES IN THE BACK CENTER OF THE CAR EVEN IF THEY ARE NON-WORKING EXHAUST PIPES.
10. USE BIG TRUCK INTER-FENDER LINERS FOR THE INNER-FENDER WHEEL-WELL SPLASH-SHIELDS WHICH YOU SCREW IN PLACE ABOVE THE TIRES.
11. SCREW THE LAMBO DOORS SHUT TO THE BODY OF THE CAR AND ADD THE REAR-VIEW MIRRORS AND INSIDE DOOR PANELS TO THE LAMBO DOORS. BONDO AND PAINT WILL HIDE THE SCREW HEADS.
12. PAINT THE CAR LAMBO METALLIC YELLOW WITH BLACK ACCENTS AS A SUGGESTION.
13. NOTE: THE V6 FIERO IS 160 H.P. AND THE WHEEL BASE IS 93.4” LONG. THE 1997 PORSCHE BOXSTER IS 217 H.P. BUT COSTS TOO MUCH MONEY TO USE AS A DONOR CAR. THE 1990 TOYOTA MR2 IS 130 H.P. AND HAS A MUCH BETTER INTERIOR AND MOTOR THAN THE FIERO. THE MR2 IS ALSO AVAILABLE IN A TURBO VERSION. IN 1993 TOYOTA INCREASED THE SIZE OF THE REAR TIRES AND CHANGED THE SUSPENSION TO INCREASE CORNING AND STABILITY. THE 1990-1995 MR2 WHEELBASE IS 94.5 INCHES LONG SO YOU WILL STRETCH THE MR2 ONLY 9.5” TO MAKE THE MERCY-2 FIT THE CAR. THE MOST DESIRED DONOR CAR FOR THIS PROJECT IS A 1993 MR2 TURBO AND THE TURBO VERSION IS ONLY AVAILABLE IN A 5 SPEED. YOU CAN SAVE MONEY BY USING A 1990 MR2 THAT IS NON-TURBO. I WOULD SUGGEST YOU GET ANY MR2 WITH FACTORY BLACK INTERIOR. NOTE: ’90-’93 MR2 TURBO RATE AT 200 H.P. AND NON-TURBO RATE AT 130 H.P. AND ’94-’95 MR2 TURBO CARS RATE AT 225 H.P. AND NON-TURBO RATE AT 135 H.P.
14. NOTE: A NON-TURBO MR2 HAS “SW21” IN THE VIN# AND A TURBO VERSION HAS “SW22” IN THE VIN#.
15. NOTE: THE MR2 BODY STYLE WE RECOMMEND FOR THIS PROJECT WAS ONLY BUILT FROM 1990-1993 WHICH REGULAR SUSPENSION AND 1994-1995 WITH STRONGER SUSPENSION.
AdsSpy: 32 sites by this AdSense ID
AdsSpy: 32 sites by this AdSense ID
16. THE TOP OF THE DOOR FOR THE FINISHED MERCY-2 IS ONLY 33” HIGH FROM THE GROUND; THEREFORE IT IS NOT HARD TO STEP OVER INTO THE SEAT OF THE MERCY-2 BECAUSE THE CAR IS SO LOW TO THE GROUND. YOU CAN ALWAYS GET THE LAMBO DOORS WORKING CORRECTLY WHEN YOU HAVE MORE TIME TO INSTALL THE HINGE AND GAS SHOCK AND FRAMING FOR THE HINGE AND GAS SHOCK TO MOUNT TO. IF SOMEONE ASKS WHY YOU HAVE TO STEP OVER INTO THE CAR YOU CAN SAY THAT THE LAMBO DOORS ARE JUST NOT WORKING RIGHT NOW AND NEED TO BE REPAIRED. YOU ARE ACTUALLY IN THE DRIVERS SEAT DRIVING THE CAR, MUCH MORE TIME THAN THE FEW SECONDS YOU ARE OPENING AND CLOSING THE LAMBO DOORS ANYWAY. THE PURPOSE OF THIS ENTIRE PROJECT IS TO KEEP YOUR SUPERCAR DREAM AS EASY AND FAST AND CHEAP AS POSSIBLE SO YOU CAN GET ROLLING AND STOP DREAMING. YOU CAN ALWAYS DO MORE WORK ON YOUR PROJECT LATER TO COMPLETE ANY PART OF IT THAT YOU CUT CORNERS ON TO SAVE TIME AND MONEY.
17. A SIMPLE WAY TO COMPLETE THE GAS TANK LID IS TO ALLOW THE OUTSIDE GAS LID TO BE A NON-WORKING LID OR HAVE NO GAS LID AT ALL AND SIMPLY BONDO OVER THE GAS LID HOLE. INSTALL A HOSE THAT RUNS TO THE GAS TANK WITH A PLASTIC GAS CAP ON THE END OF THE HOSE INSIDE THE ENGINE COMPARTMENT. WHEN YOU FILL THE CAR UP WITH GAS YOU WILL SIMPLY REMOVE THE REAR HATCH TO ACCESS THE GAS CAP THAT YOU WILL SCREW OFF THE RUBBER HOSE SO YOU CAN FILL THE CAR WITH GAS.
18. YOU CAN ALWAYS SAVE $4,000.00 AND GO WITH THE MERCY-1 TO COMPLETE THIS PROJECT.
19. FOR THIS PROJECT WE DO NOT SEND YOU THE INTERIOR KIT PIECES THAT YOU DO NOT NEED BUT WE INCLUDE THE FIBERGLASS STORAGE TOP FOR FREE THAT KEEPS THE RAIN OUT OF YOUR CAR WHILE THE CAR IS PARKED OR STORED SO YOU CAN LEAVE THE CAR OUTSIDE IF YOU DON’T OWN A CAR GARAGE. 20. WHEN YOU ARE ORDERING WHEEL SPACERS YOU SIMPLY GO TO WHEELADAPTER.COM AND TELL THE OWNER FRED HOW MANY INCHES HIGH YOU NEED THE SPACER TO BE IN ORDER FOR THE LAMBO WHEELS TO BE FAR ENOUGH OUT FROM THE MR2 HUB AND THEN YOU TELL HIM THE BOLT PATTERN FOR EACH OF THE TWO DIFFERENT WHEEL TYPES. FOR EXAMPLE IF YOU HAVE A 93-95 MR2 THE BOLT PATTERN IS 5 X 4.50 WHICH IS ALSO 5 X 114.3 AND THE BOLT PATTERN FOR THE REAL LAMBO WHEEL IS 5 X 4.72 WHICH IS ALSO 5 X 120. SOME WHEELS ARE DEEP-DISH WHICH MEANS THE FACE OF THE WHEEL SETS INSIDE THE WHEEL MORE AND IS NOT OUT NEAR THE EDGE OF THE WHEEL. DEPENDING ON THE TYPE WHEEL YOU USE DETERMINES THE LENGTH OF SPACER. FOR ONE CAR RECENTLY COMPLETED THE FRONT SPACERS WERE 2.5” HIGH AND THE REAR WHEELS USED A 1/4” SPACER.
21. YOU DO NOT WANT TO USE A 2000-2005 TOYOTA MR2 BECAUSE THAT CAR ONLY HAS 4 LUGS ON THE WHEEL HUBS.
22. YOU CAN ADD A EUROPEAN CAR TAG ON THE FRONT BUMPER.
23. YOU CAN ADD THE SMALL TRIANGLE MARKER LIGHT ON THE FENDERS.
24. YOU CAN ADD SOME WINDOW TINT TO THE INSIDE PART OF THE CLEAR HEADLIGHT LENSES AND TINT ABOUT 7” OF THE TOP SECTION OF THE WINDSHIELD.
25. YOU CAN ADD THE SMALL DECAL ABOVE THE SIDE ROCKER PANEL VENTS.
*****************************************************************************************
COST $12,000.00 =
1. THE 1990 MR2 CAR $1,000.00 WRECKED AND REPAIRED TO MAKE IT DRIVABLE.
2. MERCY-2 BODY $8,000.00
3. WHEELS $2,000. FROM EBAY OR CHEAPER IF NOT REAL LAMBO.
4. LABOR TO STRETCH MR2 AND INSTALL BODY-KIT YOU CAN DO THIS YOURSELF (OR PAY AROUND $2K FOR SOMEONE TO DO IT FOR YOU.)
5. PAINT JOB $1,000.00
6. OPTIONS: YOU CAN USE THE MR2 STEREO OR ADD AN UPGRADED, TOUCH-SCREEN PIONEER STEREO SYSTEM $300.00 FROM EBAY. BUY THE PIONEER AVH-P3100DVD 5.8” LCD, DVD, CD, MP3 CAR STEREO. THIS STEREO UPGRADES THE DASH OF THE MR2 TO A 2010 VERSION CAR WITH THE TOUCH SCREEN STEREO SYSTEM.
7. YOU MAY WANT TO SPEND MORE MONEY FOR A BETTER PAINT JOB BUT THAT IS UP TO YOU.
8. TO SAVE MONEY ON WHEELS YOU CAN BUY THE OLDER DIABLO WHEELS OFF EBAY OR GALLARDO OR COUNTACH OR USED NON-LAMBO AFTER MARKET WHEELS.
*****************************************************************************************
PACKAGE #1″ ORDER AND YOUR SHIPPING ADDRESS AND CONTACT
PHONE NUMBERS FOR THE TRUCK DRIVER AND WHAT EXTRA ACCESSORIES
YOU NEED IN ADDITION TO THE ACCESSORIES THAT ARE INCLUDED IN THE
“MURCY-2 PACKAGE #1″ LIKE A MOTOR COVER FOR EXAMPLE AND HOW
YOU WOULD LIKE TO PAY YOUR DEPOSIT AND YOUR BALANCE DUE.
AND WATCH THE VIDEOS TO LEARN HOW TO STRETCH THE DONOR CAR AND WHAT OTHER SUPPLIES AND ACCESSORIES ARE NEEDED TOnCOMPLETE YOUR PROJECT FOR EXAMPLE THE WINDSHIELD IS FROM
A 1996 NISSAN MAXIMA AND IT COSTS AROUND $150.00
*NOTE: THE SPORT FRONT BUMPER AND SCOOPED HOOD IS ON THE
*WE RECOMMEND YOU BUY FROM EBAY AND INSTALL A PIONEER
AVH-P3100DVD 5.8″ LCD STEREO IN YOUR CAR FOR AROUND $300.00.
*NOTE: YOU MAY WANT TO ADD THE FOLLOWING ACCESSORIES TO
YOUR ORDER AT ADDITIONAL COSTS:
-A LARGE REAR SPOILER FOR $700.00 (SEE BLUE CAR ON MURCY-2 PAGE PHOTO) OR
-A REPLICA MOTOR COVER FOR $450.00 (SEE MURCY-1 PAGE) OR
-A REPLICA STEERING WHEEL COVER INSERT FOR $75.00 WHICH
YOU USE WITH A THREE SPOKE RACING STEERING WHEEL FROM
EBAY OR A PARTS STORE. YOU CAN GET THE STEERING WHEEL
FOR ABOUT $40.00 (SEE MURCY-1 PAGE) OR
-A FIERO HEADREST ATTACHMENT SET $100.00 FOR BOTH
(SEE MURCY-1 PAGE) OR
-THE INNER SIDE PANEL SECTIONS THAT GO BETWEEN THE
SEAT AND THE DOOR $300.00 FOR BOTH SIDES (SEE MURCY-1 PAGE)
-IF YOU BUY THE MURCY-2 N.T. (NO TOP) VERSION YOU MAY
WANT THE MURCY-2 N.T. RAIN COVER FOR $200.00 WHICH IS
FOR STORING YOUR CAR OUTSIDE. (SEE MURCY-2 PAGE FOR PHOTO)
-NOTE: THE MOST POPULAR VERSION OF THIS BODY-KIT IS THE “MURCY-2 N.T. PACKAGE #1 WITH THE SPORT FRONT BUMPER
AND A REGULAR FRONT HOOD” AND THEN ADD THE MOTOR COVER AT $450.00, AND THE REPLICA STEERING WHEEL COVER AT $75.00, AND THE FIERO HEADRESTS AT $100.00 AND THE INNER SIDE-PANELS
